Industrial Vacuum Trucks & Equipment
MANUFACTURING - SALES - PARTS - SERVICE
780 955-9344
Equipment Model: Wet Dry Vac Units

Wet Dry Vac

Western Star


MA#: CV-Wet-Dry
Model: Wet Dry Vac
Code: Non-Code
Blower:
Located:
Status: Custom Built Units

Custom Built Units:

Contact a Sales Representative to get more details about having a custom vacuum truck built to fit your exact needs.


Tel: 780 955-9344

Email Sales
CV6400 Non Code Wet/Dry Vac  - Standard Unit Configuration

Base Model - Unit displayed above may differ for the standard configurations.
Please contact a sales representative for more details about the unit listed above.

Design: Vacuum debris tank shall withstand 14.9 PSI Internal Pressure and 15 PSI External pressure (full vacuum) UNIT NOT FOR TDG!

Debris Tank

Derbris Compartment:

  • Diameter 78" x 11' seam to sem
  • Capacity 11 cubes ( 2420 Imp Gal )
  • 78" x 5/8" rear plate
  • Two 7816' head
  • 78" x 3/" x 5/16"x 6' shells
  • Preformed tank pedestals
  • Liquid level indicator D/S
  • Hydraulic lifr rear ( door) gate mechanism
  • 4" Heated Brass manual gate valve
  • 6" Heated Brass manual gate galve
  • Ladder c/w step platform D/S at rear of tank for boom access
  • Dig tube holders off of P/S rear door
Blower

Blower:

  • Robuschi RB-DV 145 ( 6400 CFM ) free air rating @ 27" Hg maximum
  • Vacuum. Blower equipped with low noise discharge manifold

Blower Drive:

  • Transfer case drive with air shift engagement mounted in truck driveline
  • Driveline modifications as required
Hydraulic System

Hydraulic System:

  • 8 Bolt PTO
  • Tandem gear pump
  • Spool type valve control
  • Rear control bank for rear gate
  • 40 Gallon oil tank c/w vent,site glass filters, temperature gauge, and inspection hatch  
  • 12 volt oil cooler
  • 3 Stage d/a hoist cylinder

Primary Shut-Off:

  • Daul heavy duty internal shut-offs with 12" S.S. float ball/cage assembly and 8" Turbo boot and Dual 8" flanged outlets
  • Dual 8" isolation valves air actuated with switches at operator station

Plumbing:

  • 12" piping from prestage to cyclones c/w 8" oil and gas loop hose
Vacuum Equipment

Vacuum Breakers:

  • Four vacuum breakers installed on cyclone plumbing D/S

Isolation Valves:

  • One 6" air actuated valve between cyclone and prestage to isolate cyclones for dry mode

Silencers:

  • One 12" exhaust silencer, One intake silencer in Horizontal mount configuration

Filtration System:

  • Dual high efficiency cyclones mounted on drivers side of unit with 20" drop box assembly and swing out cleanout doors ,3" brass manual drain valves with camlock fittings
  • Prestage filter housing c/w 20" diameter washable inline S.S./fiber filter element,

Baghouse Assembly:

  • Dual cylindrical 1/4" steel construction witrh 1.2 cube capacity
  • Top door hinged access
  • Each baghouse c/w 30 Acrylic coated filter bags
  • Filters cleaned automatically with a timed air blaster assembly
  • 4" cleanouts Caped  at bottom of each  baghouse

Vibrator:

  • Global vibrator assembly mounted bottom of tank on reinforcement pad HD
  • Channel and pressure relief valve

Pressure Relief:

  • One 3" x 15 PSI relief vent
Equipment

Frame,Deck And Allied Equuipment:

  • Full length subframe c/w 1/8: checker plate, hose tray/fender assembly,
  • Heavy durt outrigger supports, 1 1/4" thube handrails,close in plate Standard rear
  • bumper with lightboxes module and rear tire skirt
  • Subframe supports decking,rear hoist hinges & front hoist cradle

Hydraulic Boom:

  • One 8" x 270 deg. Telescopic suction boom mounted top rear of debris tank
  • 8' Boom Hose c/w aluminum adapter end
  • One wireless remote control
  • One Hard wired pendant control c/w cable and plug in

Gauges:

  • Gauge assembly with tank vacuum/pressure gauge, hydraulic pressure gauges.  Blower temperature gauge - remote mounted on D/S.

Trim:

  • 50' ground cable assembly wind up style

Electrical System:

  • Waterproof main circuit control box - self contained power supply.
  • Sealed wire harness c/w waterproof junction boxes.
  • L.E.D. lamps (Clearance, park, signal).
  • Sealed L.E.D. reverse lamps.
  • Four L.E.D.  work lights
  • Lights are dual revolution and all red lights turn white when in reverse
  • Electrical system shut-down at key.
  • Sealed rear skirt lamp modules.
  • Stop and turn L.E.D sealed lamp modules on top ring of door.
  • Back up alarm

Bumper:

  • Standard non code rear bumper

Painting:

  • The entire tank and body of vacuum system shall be sandblasted, primed
  • and painted with Endura paint. Color to meet company fleet color    

Additional Equipment:

  • PTO Hour meter installed in truck cab
  • 30# fire extinguisher/Brkt/Cover
  • Mudflaps
  • Boom cradle top of tank &  hose holders P/S
  • Chain hanger slide out style

Other Items:

  • Operators manual
  • National Safety Mark
  • One Year Standard Manufactures Ltd Warranty

Installation:

  • Complete system installed on Customer Supplied Tandem axle truck chassis.
Contact Sales
LISTINGS - Wet Dry Vac Units

Wet Dry Vac

Western Star
Custom

MA#: CV-Wet-Dry
Model: Wet Dry Vac

National and International Sales

Custom Vac Service Ltd. offers custom built industrial vacuum equipment manufactured at our modern facility located in Nisku Alberta. Custom Vac Service Ltd. has a large inventory of vacuum trucks in production, ready for pant and for immediate delivery as well as a large inventory of vacuum trucks for rent or lease. 

Custom Vac's offers top quality industrial vacuum equipment for local, national and international sales. Custom Vac Service Ltd. offers equipment for export to the United States, Mexico and South America and welcomes inquiries from international customers requiring high quality custom built vacuum trucks.

A representative is available to answer any questions you may have about renting, leasing or purchasing a Vacuum Truck.